= 27d567bc2d48d9f40e9ccc20ea370b15)
simplicio comments on Procedural Knowledge Gaps - Less Wrong
You are viewing a comment permalink. View the original post to see all comments and the full post content.
= 783df68a0f980790206b9ea87794c5b6)
Loading…= b715d02e85f7b3b4ae65ca3d3e450868)
Subscribe to RSS Feed
Powered by Reddit
= f037147d6e6c911a85753b9abdedda8d)
You are viewing a comment permalink. View the original post to see all comments and the full post content.
Comments (1477)
I would say that the key is to experiment with various techniques, razors, foams & soaps until you find one that works. I had to go through several razors and several soap/foam products until I found a combo that didn't give me burns.
I always shave in the bath, making sure my face has been wet for a few minutes. I lather up with ordinary, cheap-as-dirt soap. The razor I have found works for me is the 5-blade MACH TURBO SUPERSONIC STEALTH type you see advertised all the time these days. Very hard to cut yourself with them unless you move it sideways and with pressure.
One crucial recommendation is to shave upwards from the bottom of your neck to the top. This takes a lot of getting used to and really gave me the willies at first, but it works much better and you miss a lot less hair.
Really? I have the exact opposite experience. I find that going against the grain, especially on the neck, gives me nicks and rashes.
After having experimented a lot, what works for me is wetshaving using any ol' shaving cream, multi-blade razor, going with the grain.
Since facial hair grows in different directions this means you have to pay attention to it. Briefly, I shave top-down on the face and away from the chin on the neck.
For a very smooth shave, I sometimes do it with the grain, a second time against the grain and a third time with it. I read somewhere that the third time is important to avoid ingrown hair and rashes and in my case it works, but YMMV.